Heater control unit & 120Vac 33W, 2 thermocouple, 54cm cord, 9cm x7.5cm
HEATER-KIT-1LG
Heater Kit is shown for demonstration purposes. Syringe pump and syringe are not included with Heater Kit.
Description:
Thermo-Kinetic Heat Clamp for syringes that require temperature-controlled dispensing. Heats up to 185°C.
Specification Notes:
Available in 2 versions:
1LG Heating Pad: 3.5" x 3.0" LxW (9 cm x 7.5 cm)
5SP Heating Pad: 20" x 0.625" LxW (50 cm x 1.5 cm)
Heater Kit includes control unit and primary syringe heater pad 1LG version or 5SP version.
Multiple syringe heater pads can be attached to the control unit, under restricted conditions.
Set point and other parameters retained in memory
Digitally sets the heater set point
Controller will heat the syringe and hold the set temperature using an on/off or Thermo-kinetic control algorithm.
Dual temperature sensors in primary heating pad.
Alarm modes with multiple layers of protection to prevent temperature overrun.
Additonal heat protection for the pump may be needed when heating syringes above 100°C.
If you are in a country where the voltage is above 120V, you must purchase a step-down transformer (Model: PWR-220-110-E) along with the Heater Kit.
現貨,附件,HEATER-KIT-1LG,加熱器控制單元和注射器加熱墊
滬公網安備31011502016460號
